When laser cutting lead glass, a glass knife can be used for thin glass, but it is cost-effective because lead glass has a large specific gravity and contains a lot of lead. It is soft in strength and X-ray-resistant glass is brittle. Laser cutting with an automatic cutting machine for diamond grinding sheets, the actual laser cutting of lead glass for medical equipment X-ray-proof glass cutting X-ray-proof glass in the following ways:

1. Clean the surface of the lead glass of the anti-x-ray glass medical equipment prepared in advance for laser cutting. The stains and irregularities on the lead glass of all medical equipment X-ray glass prevent you from scratching all the time. Use a towel or finger to wipe the area where you need to scratch.

2. Then, prepare a laminated glass cutter and some high-viscosity oil in advance. The specification of the lead glass cutter is similar to that of a signature pen. Use diamond or hard sand wheel to scratch the laminated glass. The lead glass of medical equipment can be cut apart along the scratches. You can buy cooking oil for laser cutting at the hardware store or use some gasoline.

3. Secondly, accurately measure and mark the anti-X-ray glass to identify the area where you need scratches. The scratches must be from one side edge to the other side edge. You can use an oil-based marker to mark on the laminated glass, or you can use paper Make the logo, and then spread the paper under the lead glass of the medical equipment. The length of the laser cutting is not suitable for too long. Scratches beyond 60 cm increase the risk of cracking large laminated glass.

4. Make sure that the scratch line has about 15 cm of edge on both sides to free up the indoor space for grabbing objects. If you laser cut a small piece of medical equipment X-ray anti-glass material lead glass, you will need special tools such as needle-nose pliers or A small hammer for smashing lead glass of medical equipment that you can't grab with the X-ray-proof glass. Scribe on the laminated glass and infiltrate the cutting knife into the oil, hold the oil-soaked laminated glass cutting knife like a signature pen, you can draw a smooth line, make sure to check that the sand wheel points to the part and orientation you want .